Models made by Airbrushheaven staff

Models made by Airbrushheaven staff

Friday 29 May 2015

1:12 Tamiya Porsche 910 :- 3- More engine block work

Back to stage 4 & fitted the cylinder heads to the engine block & the front mounting point (Part H4).  I checked beforehand that the fan belt would still go on at a later stage if I was to fit the mounting block.

Next was to make up the main gearbox housing bar the rear mounting plate (Part A6). After filling then sanding fixed it to the engine block leaving off the filter & starter motor. I made the air intake parts (H12 & E3). Fitted these to the top of the block.

The whole unit was then sprayed with a few light coats of Vallejo "Model Air" Aluminium (71.062). I then just gave it a light mist of "Model Air" Steel (71.065)

Sprayed engine & gearbox unit of Porsche 910


No comments:

Post a Comment