Now to work on the Ingram’s arms.
The top joints are both
the same & as they will not be seen on the finished kit I just screwed them
together as in section 11 of the manual.
The right hand side lower arm is meant to slide down so he can reach the
gun mounted in the leg & does need a bit of work.
The sides of the arm & rear plate E6 were painted Plate
Mail primer, the sliding beam & fixing clip in Magnesium & the piston
in Plate Mail & a copper top section. The left arm comes in just 2 pieces
& was done in Plate Mail & copper. The outer armour pieces (B30,B31,B32
& B33) were sprayed in the White primer.
The hip joint is a simple 3 piece unit that screws together,
the connecting joint D13 pushed into place, then sprayed in Plate Mail primer.
The outer casing for the hips (B38) had the winch fitted
& then sprayed in White primer. The
winch cable was hand painted in Aluminium & then a black wash to bring out
the depth of the cable more.
This unit then pushes into the waist section that was done
back on part 2 of this blog.
No comments:
Post a Comment